DB Drive A6 Manuel d'utilisateur télécharger pdf (Page 7)

network that allows you to select the crossover mode (Highpass—Full Range) and desired

crossover point for channels 1 and 2. Channels 3 and 4 allow you to select between a

Highpass 12db slope, a 12db Stereo Lowpass / Bandpass slope and a mono 24db Lowpass /

Bandpass slope. For example if you wish to drive a pair of subwoofers on channels 3 and 4

out the high frequencies with a 24db slope. You will then need to adjust the Lowpass

control to the desired frequency setting (make sure to have the Highpass control set to

switch to LP/BP stereo. Once the LP/BP stereo switch setting is selected you will use both

any unwanted low frequencies with a 12db slope.

The A6 1600.1D, A6 1900.1D and A6 2800.1D are equipped with a variable 24db slope

feature a variable Bass Boost EQ is set at 45Hz. In some subwoofer enclosure installations it

may necessary to use the Phase Shift feature. The Phase Shift button sets the Subwoofer

subwoofer enclosure. All A6 mono amps are also equipped with Multi-Linking technology.

When using a single A6 mono amp set the Master / Slave switch to the Master position.

the slave setting the front panel controls become inoperative. All adjustments for both

( A6 800.4, A6 1200.4, A6 1600.4 ) ( A6 1600.1D, A6 1900.1D, A6 2800.1D )

Master Amp

Slave Amp

Select Master

Select Slave

RCA input

Master controls

Slave controls are void

2 ohm minimum

Multi-Link

Diagram

1 2 3 4 5 6 7 8

Pas de commentaire

DB Drive A6 Manuel d'utilisateur Page 7